Quality RTOS & Embedded Software

 Real time embedded FreeRTOS RSS feed 
Quick Start Supported MCUs PDF Books Trace Tools Ecosystem


Program dies upon continuing from a breakpoint

Posted by digitalwiz on September 1, 2016

I have a very simple two task program running on a LPCXpresso LPC1769 under LPCXpresso v8.2.0. If I run the program with no breakpoints, or if breakpoints are disabled, it runs fine. But if it takes the breakpoint, then upon resuming the program dies with this message: Thread #1 1 (runnable) (Suspended : Signal : SIGSTOP:Stopped (signal)) 0xffffffff

I'm guessing I'm missing some configuration option.

TIA, Doug

Program dies upon continuing from a breakpoint

Posted by rtel on September 1, 2016

Hi Doug. You might get better answers posting this to the LPCXpresso forum as I think it is probably tools related rather than FreeRTOS related. Perhaps a timer or clock or continuing to run while the processor itself is stopped (just guessing!).

[ Back to the top ]    [ About FreeRTOS ]    [ Privacy ]    [ Sitemap ]    [ ]

Copyright (C) Amazon Web Services, Inc. or its affiliates. All rights reserved.

Latest News

NXP tweet showing LPC5500 (ARMv8-M Cortex-M33) running FreeRTOS.

Version 10.1.1 of the FreeRTOS kernel is available for immediate download. MIT licensed.

View a recording of the "OTA Update Security and Reliability" webinar, presented by TI and AWS.


FreeRTOS and other embedded software careers at AWS.

FreeRTOS Partners

ARM Connected RTOS partner for all ARM microcontroller cores

Espressif ESP32

IAR Partner

Microchip Premier RTOS Partner

RTOS partner of NXP for all NXP ARM microcontrollers


STMicro RTOS partner supporting ARM7, ARM Cortex-M3, ARM Cortex-M4 and ARM Cortex-M0

Texas Instruments MCU Developer Network RTOS partner for ARM and MSP430 microcontrollers

OpenRTOS and SafeRTOS

Xilinx Microblaze and Zynq partner